Switching fog light and rear fog light on or off
Requirements:
R
The light switch is in position
L
or
Ã
.
R
The voltage supply or engine is on.
#
Switching the fog light on or off: press the
7
button.
#
Switching the rear fog light on or off:
press the
6
button.
Comply with the country-specific regulations for
using the rear fog light.
Regulating headlamp range
Requirements:
R
the engine is running.
You can use the headlamp range controller to
adjust the light cone of the headlamps to the
vehicle's load condition. As the seats are occu‐
pied or the load compartment is loaded or unloa‐
ded, the light cone changes. This can cause visi‐
bility conditions to deteriorate and you could daz‐
zle oncoming traffic.
%
In vehicles with LED headlamps, the head‐
lamp range is adjusted automatically.
g
Driver's and front passenger seat occupied
1
Driver's seat, front passenger seat and rear
seats occupied
2
Driver's seat, front passenger seat and rear
seats occupied, load compartment or loading
area loaded
3
Driver's seat and front passenger seat occu‐
pied and using the maximum permitted rear
axle load
#
Turn the headlamp range controller to the
corresponding position.
The road illumination should be 40 m to
100 m and the dipped beam must not dazzle
oncoming traffic.
#
If the vehicle is unloaded, select the
g
posi‐
tion.
Operating the combination light switch
1
High beam
2
Right indicator
3
Headlamp flasher
4
Left indicator
#
To indicate: push the combination switch in
the required direction
2
or
4
until it
engages. In the case of larger steering move‐
ments, the combination switch automatically
switches back.
#
To indicate briefly: tap the combination
switch briefly in the required direction
2
or
4
. The corresponding turn signal light
flashes three times.
#
To switch on the high beam: switch on the
dipped beam (
/
page 86).
#
Press the combination switch forwards
1
.
The indicator lamp
K
on the instrument
cluster will light up. The combination switch
will return to its starting position.
%
The high beam switches to position
Ã
only in darkness and when the engine is run‐
ning.
#
To switch off the main beam: push the
combination switch
1
forwards or briefly
pull it in the direction of the arrow
3
(the
Light and vision
87
