Raising and lowering the vehicle level
Using the remote control
The remote control is located in a holder on the
B‑pillar on the driver's side. Remove the remote
control from the holder before use.
Electronic level control performs a self-check reg‐
ularly when it is activated and while in use. Indi‐
cator lamp
1
on the remote control lights up for
approximately one second when you switch on
either the ignition or electronic level control with
button
4
.
There is a malfunction if indicator lamp
1
behaves in the following ways:
R
the indicator lamp does not light up when you
switch on the ignition or electronic level con‐
trol
or
R
the indicator lamp does not go out after one
second
or
R
the indicator lamp then lights up again or
flashes
In addition, a warning tone is emitted from the
remote control for approximately 30 seconds.
The fault that has been detected can be shown
using the indicator lamps (signalling of fault
codes).
#
Park the vehicle, leaving the ignition switched
on.
#
To raise or lower the vehicle level: press
and hold button
2
or
3
until the vehicle
level reaches the required height.
The indicator lamp on button
2
or
3
flashes as long as the vehicle level is being
changed. When the vehicle level has been set,
the indicator lamp on button
2
or
3
lights
up.
#
To lower automatically: briefly press button
3
.
Electronic level control automatically lowers
the vehicle down to the lowest position.
The indicator lamp on button
3
flashes as
long as the vehicle level is being changed.
When the vehicle level has been set, the indi‐
cator lamp on button
3
lights up.
#
To stop the movement, briefly press button
2
.
#
To raise or lower to driving level: briefly
press button
2
or
3
.
Electronic level control automatically raises or
lowers the vehicle to driving level.
The indicator lamp on button
2
or
3
flashes as long as the vehicle level is being
changed. When the vehicle level has been set,
the indicator lamp on button
2
or
3
lights
up.
#
To stop the movement, briefly press the other
button.
#
To save the set vehicle level: set the
required vehicle level.
#
Press and hold button
5
or
6
until you hear
a tone.
The vehicle level set has been saved on corre‐
sponding button
5
or
6
.
#
To call up the saved vehicle level: briefly
press button
5
or
6
.
Electronic level control automatically raises or
lowers the vehicle to the saved driving level.
The indicator lamp on button
5
or
6
flashes as long as the vehicle level is being
changed. When the vehicle level has been set,
the indicator lamp on button
5
or
6
lights
up.
#
To stop the movement, briefly press button
2
or
3
.
#
To switch on automatically: drive at over
10 km/h or release the parking brake.
Electronic level control controls the vehicle
level automatically.
#
To stop the movement, briefly press button
2
or
3
.
Switching electronic level control off/on
#
To switch electronic level control off:
press button
4
.
The indicator lamp on button
4
lights up.
Driving and parking 137