R
You switch on the turn signal.
R
A driving safety system intervenes, such as
ESP
®
or Active Brake Assist.
R
You have adopted a sporty driving style with
high cornering speeds or high rates of accel‐
eration.
R
ESP
®
has been switched off.
R
When driving with a trailer, the electrical con‐
nection to the trailer has been correctly
established.
R
If a loss of tyre pressure or a defective tyre
has been detected and displayed.
The system may be impaired or may not function
in the following situations:
R
There is poor visibility, e.g. due to insufficient
illumination of the road, highly variable shade
conditions, or due to rain, snow, fog or heavy
spray.
R
Dazzle from oncoming traffic, direct sunlight
or reflections.
R
There is dirt on the windscreen in the vicinity
of the multifunction camera or the camera is
misted up, damaged or obscured.
R
No or several, unclear lane markings are pres‐
ent for one lane, e.g. in a construction area.
R
The lane markings are worn, dark or covered.
R
The distance to the vehicle in front is too
small, and therefore the lane markings cannot
be detected.
R
The lane markings change quickly, e.g. lanes
branch off, cross one another or merge.
R
The carriageway is very narrow and winding.
Activating/deactivating Lane Keeping Assist
or Active Lane Keeping Assist
Multimedia system:
4
©
5
Settings
5
Assistance
#
Select
Lane Keeping Assist
or
Act. Lane
Keep. Asst On
.
Activating or deactivating warning
#
Select
Lane Keeping Assist
or
Act. Lane
Keep. Asst On
.
#
Select
Warning
.
Work mode
Activating/deactivating power take-off
Observe the following notes:
R
if there is severe strain on the power take-off,
e.g. due to a high power draw at high outside
temperatures, the transmission oil tempera‐
ture can increase to impermissible levels. In
this case, operate the power take-off at regu‐
lar intervals for about five to ten minutes
under a partial load.
R
only activate the power take-off when the
vehicle is stationary and the transmission is
in neutral position.
R
make sure that the engine speed is not higher
than 2500 rpm during operation.
R
manual transmission is disabled in vehicles
with shift lock when the power take-off is
activated.
R
you can engage 1st or 2nd gear and drive
after activating power take-off in vehicles
without shift lock. Do not change gear while
the vehicle is in motion when power take-off
is activated. Therefore, pull away in 1st or
2nd gear depending on the desired speed.
R
observe the notes in the manufacturer's oper‐
ating instructions before using the power
take-off in conjunction with the body.
#
To activate: stop the vehicle and shift the
transmission to neutral.
#
depress the clutch pedal.
#
wait about five seconds and with the engine
running press the upper section of the switch
1
.
#
release the clutch pedal.
On vehicles with a working speed governor
(ADR), the engine speed automatically increa‐
ses to a preset speed or a speed you have
set, the constant engine speed. The
Working
speed governor active
and
Power-take off
174 Driving and parking
