%
Do not turn pressure release screw
3
more
than one or two full turns. Hydraulic fluid
could otherwise escape.
#
Insert pump lever
1
with the largest rod into
the recess on the jack and secure by turning
it clockwise.
#
Place the jack vertically beneath the jack sup‐
port points described below.
Jack support point, front axle
Jack support point, rear axle (example: plat‐
form vehicle up to 3.5 t)
Jack support point, rear axle (example: panel
van and crewbus up to 4.0 t)
Jack support point, rear axle (vehicles 5.0 t)
#
Place the jack beneath the jack support
point.
#
Vehicles with all-wheel drive: turn jack
spindle
2
anti-clockwise as far as it will go.
#
Raise the vehicle until the tyre is raised a
maximum of 3 cm off the ground.
#
Loosen and remove the wheel (
/
page 339).
Removing a wheel
Requirements:
R
The vehicle is raised (
/
page 337).
When changing a wheel, avoid applying any
force to the brake discs since this could
impair the level of comfort when braking.
Wheels and tyres 339