Mercedes-Benz EQS 2021, Operator'S Manual

Page: 234 / 928

ULTRA RANGE Highbeam increases the bright-
ness of the cone of light to the legally permitted
maximum.
Partial high beam does not include other road
users in the high beam area. It does not dazzle
them but enables full high beam illumination for
the driver apart from the excluded vehicles.
At speeds below 25 km/h or when there is suffi-
cient street lighting:
R
The partial high beam and the high beam will
be switched off automatically.
At speeds greater than 30 km/h:
R
If no other road users are detected, the high
beam will switch on automatically.
R
If other road users are detected, the partial
high beam will switch on automatically.
At speeds above 40 km/h:
R
If no other road users are detected on a
straight road, ULTRA RANGE Highbeam will be
switched on automatically.
R
If other road users are detected, the partial
high beam will switch on automatically.
R
If highly reflective signs are detected, ULTRA
RANGE Highbeam will be switched off auto-
matically.
%
The system's optical sensor is located behind
the windscreen near the overhead control
panel.
▌ Switching Adaptive Highbeam Assist Plus
on/off
&
WARNING Risk of accident despite Adap-
tive Highbeam Assist Plus
Adaptive Highbeam Assist Plus does not react
to:
R
road users without lights, e.g. pedestrians
R
road users with poor lighting, e.g. cyclists
R
road users whose lighting is obstructed,
e.g. by a barrier
On very rare occasions, Adaptive Highbeam
Assist Plus may fail to recognise other road
users with their own lighting, or may recognise
them too late.
In these, or in similar situations, the automatic
high beam will not be deactivated or will be
activated despite the presence of other road
users.
#
Always observe the road and traffic con-
ditions carefully and switch off the high
beam in good time.
Switching on
#
Turn the light switch to the
Ã
position.
#
Switch on the high beam using the combina-
tion switch.
If Adaptive Highbeam Assist Plus is activated,
the
_
indicator lamp will light up on the
driver's display. When partial high beam or
high beam is active, the corresponding blue
indicator lamp will also light up.
Switching off
#
Switch off the high beam using the combina-
tion switch.
232 Light and sight
ohne