Mercedes-Benz E-Class Sedan, Operator'S Manual

Page: 385 / 498

1
Front roof area
2
Rear roof area
3
Rear fender
4
Trunk lid
On vehicles with a panoramic sliding sunroof,
installing an antenna to the front or rear roof
area is not permitted.
On the rear fenders, it is recommended that you
position the antenna on the side of the vehicle
closest to the center of the road.
Use Technical Specification ISO/TS 21609 (Road
Vehicles – "EMC guidelines for installation of
aftermarket radio frequency transmitting equip‐
ment") when retrofitting two-way radios. Comply
with the legal requirements for detachable parts.
If your vehicle has two-way radio equipment
installed, use the power supply or antenna con‐
nections intended for use with the basic wiring.
Be sure to observe the manufacturer's supple‐
ments during installation.
Two-way radio transmission output
The maximum transmission output (PEAK) at the
base of the antenna must not exceed the values
in the following table:
Frequency band and maximum transmission
output
Frequency band Maximum transmis‐
sion output
Short wave
3 - 54 MHz 100 W
4 m waveband
74 - 88 MHz 30 W
2 m waveband
144 - 174 MHz 50 W
Trunked radio sys‐
tem/Tetra
380 - 460 MHz
10 W
70 cm waveband
420 - 450 MHz 35 W
Mobile communica‐
tions (2G/3G/4G)
10 W
Technical data 383