McConnel ROBOPOWER 111300001, Operator'S Manual

Page: 89 / 96

85
9.14 - SERVICE EVERY 500 HOURS
9.14.1 - OIL REPLACEMENT
For the replacement of the oil of the drive motor units
perform the following operations:
- Place the machine on a level surface, and turn the
tracks until the drain plug is at the bottom of the gear-
box.
- Turn off the engine and remove the ignition key;
- Open the cap level.
ATTENTION: Remove the oil plugs with
extreme caution because an overpressure inside
the unit could strongly expel them.
“ }" ^}
large enough container; in order to facilitate the
draining must be oil still warm.
Wait a few minutes until all the oil is drained and
then proceed to screw on the plugs.
‘}{"
following procedures listed in Section 9.4
Oil Livel
DANGER :
The oil may be spilled during the change could cause to slip; then wear protective
clothing and sturdy shoes immediately and remove all traces of oil.
Do not dispose of the oil in the natural environment but be careful to eliminate it
in compliance with the relative rules and regulations that govern locally.
- McCONNEL ROBOPOWER -