50
3)Turn on the central unit (switch in “REMOTE” position)
and unlock the portable control unit emergency
stop button.
4) Hold the ON/SIGNAL (A) button for about 10 seconds
(the red light of the portable control unit turns on and
short and repeated sound signals are emitted to ensure
that programming is in progress, the internal
display of the central unit shows “Po” and “Id”).
%Zj " \"+ -
trol unit turns off and the central unit returns in stand-by
mode.
6) Leaving the cable connected, power on again the
portable control unit. If everything has worked good,
the display inside the receiver will show “1-”.
Note: if a graphic display is installed on the portable
control unit, after the second power on, it can take
-
guration. Meanwhile, on the display, some messa-
ges will inform of the work in progress. The display
inside the receiver will show a rotating segment
-
tely transfered the display inside the receiver will
show “1-”.
7) Disconnect the cable, insert the battery and test the
radio.
8) If something goes wrong repeat the procedure from
the beginning.
A
C
B
F
H
I
L
D
A
E
M
N
B
R
Q
P
O
C
G
T
S
b
b
- McCONNEL ROBOPOWER -
Summary of Contents for ROBOPOWER 111300001
