59
6.8 - HOW TO PLUG AN EQUIPMENT
The machine is equipped with two lifts (front/rear)
where its possible to plug equipments approved.
For this operation, follow the steps:
• Start the engine, after done the link with the
remote control (see cap. 6.4.1)
• Move the right joystick (H) to lower the lift.
• Lift the lever (1) and lock it in place to allow
the detent ball joints.
• Drive forward slowly until the equipment will
be in contact, previously placed in front of the
machine.
• Slowly lift the front linkage as long as the
equipment is not well lock.
• Lower the lever (1) and make sure that the
latch (2) is in place.
• Connect hyd. hoses of services to the quick
couplings (left side).
ATTENTION :
- Read and follow the instructions provided to ensure safety in the use of tools driven
by the PTO.
- Follow the instructions provided by the manufacturer of the equipment.
- Use the prescribed safety devices and make sure they are in good condition.
- Make sure that the machine is connected properly and that does not hit the other parts of the
machine when lifted.
DANGER :
When you engage or disengage gear, stand next to the machine away from the tool.
Never stand on the implement or between the machine and the tool.
Before connecting the quick couplings, the equipment must be mechanically con-
nected to the machine.
- McCONNEL ROBOPOWER -
Summary of Contents for ROBOPOWER 111300001
