The DESTOFS parameter assigns a destination offset that determines which destination the button panel starts
on, 0 is used for no offset (default). The SRCOFS parameter is used likewise to assign a source offset. The
LVL1 and LVL2 parameters are used for modifying what levels the panel will control. The default is 0 for both
values which uses the default levels of 1 and 2 for the primary and secondary levels respectively. If LVL1 is
assigned a value other than 0 and LVL2 is 0 then the secondary level control will be disabled.
Examples
>PanelOfs
0,0,0,0
>PanelOfs 1,0,0,0
>PanelOfs 0,0,2,0
>
The first command just queries the current panel offset values, which returns all 0s (the default). The second
command assigns 1,0,0,0 which sets a destination offset of 1, which will set the first destination of the button
panel to destination 2. The third command sets up a button panel to control the 2nd level of a router.
5.35 PanelProfile Command
MSC-GCP2U32 only
Query or assign the current active panel matrix profile index. This is the current matrix profile that the LCD
panel interface is controlling (refer to the
MtxProfiles Command
for details).
Command
Description
PanelProfile
Query the current panel matrix profile index.
PanelProfile PROFILE
Set the current panel matrix profile index being controlled.
Examples
>PanelProfile
1
>PanelProfile 2
>
The first example command queries the current value of the panel matrix profile index and the second command
switches the panel to control the second profile.
5.36 PanelRate Command
Protocol Version: 2.1
For changing remote button panel refresh rate. When a button panel is configured to control a remote router the
current connection status is refreshed at regular intervals. This command can be used to increase or decrease
Page 58 of 75
©
2013 Matrix Switch Corporation
www.matrix-switch.tv