2.2 Routing – Single Level
The
Routing
page is the default interface page
and the active interface after device startup.
Note:
pressing the
Cancel
button in most other
modes will return the interface to the
Routing
page.
The current routing connection matrix state is
shown, as seen in Figure 4, one item per
destination, with the destination number and label followed by the connected source number and label. The
Navigation
buttons can be used to change the currently selected item and to scroll through multiple pages if
applicable.
2.2.1 Changing a Crosspoint
There are 2 methods which can be used to change a matrix crosspoint connection called
Navigation Method
and
Key-In Method
described below.
Navigation Method
1. Navigate to the desired destination item
using the
Navigation
buttons.
2. Press the
Select
button to activate
Source Mode
.
3. The
Select Source
page is shown with
the currently connected source
highlighted (Figure 5).
4. Navigate to the source which is intended
to connect to the active destination.
5. Press the
Select
or
Take
buttons to complete the crosspoint connection or press
Cancel
to keep the
existing connection and return to the
Routing
page.
Key-In Method
1. Press the
Dest
button which will activate Destination Mode, buttons
0
through
9
,
Dest
and
Cancel
will
flash awaiting further input (Destination Mode can be canceled by pressing the
Cancel
button or after 20
seconds of inactivity).
2. Key-in the desired destination of the crosspoint change using buttons
0
through
9
and the currently
selected destination will update accordingly on the display. To re-enter the destination number, press the
Page 16 of 75
©
2013 Matrix Switch Corporation
www.matrix-switch.tv
Figure 4: Routing
Figure 5: Routing Select Source