2.7 Configuration
Configuration of the MSC-GCP2U32 is
accessed with the
Config Menu
(Figure 10) and
several sub menus each of which is described
below.
2.7.1 General Config
General configuration consists of the following
options (as seen in Figure 11):
1. Enable LCD blanking
2. LCD blank time
3. Serial baud rate
The
LCD Blanking
feature causes the LCD
backlight to be turned off after a specified
number of seconds of button inactivity.
To enable or disable this option navigate to the
configuration option and press the
Select
button
to toggle the current value. To set the LCD
blanking time, navigate to the configuration
option, press the
Select
button to activate
Edit
Mode
and use the
Up
and
Down
arrows or
PgUp
and
PgDn
to increase or decrease the value in seconds. To exit
Edit Mode
press
Select
again to save the
selected value or
Cancel
to keep the previous value.
The
Serial Baud Rate
can be changed by navigating to the configuration option, pressing
Select
to enter
Edit
Mode
and using the
Up
and
Down
arrows to change the value. To exit
Edit Mode
press
Select
again to save
the selected value or
Cancel
to keep the previous value. After changing the serial baud rate, the system needs
to be rebooted for the changes to take effect. The
Reboot
item on the
General Config
page can be used for this
purpose, by navigating to it, pressing the
Select
button and confirming the reboot dialog.
2.7.2 Network Config
The network configuration can be changed from this page as seen in Figure 12.
Page 20 of 75
©
2013 Matrix Switch Corporation
www.matrix-switch.tv
Figure 10: Config Menu
Figure 11: General Config