Manning YB8, Operating And Instruction Manual

Page: 38 / 121

PROGRAMMING SECTION MODEL YB8
April 1999/Manning Environmental Inc.
3DJH%
BACKLIGHT MODE?
__ 04:30:02
Sets whether the display backlights:
0 - Backlight is never on. This is good if power conversation is
critical.
1 - Backlight comes on when a key is pressed. The light will
automatically turn off after 3 0 seconds if another key is not
pressed.
2- Backlight comes on when a key is pressed and also at the start of
a sampling cycle. The light will automatically turn off after 3 0
seconds if another key is not pressed or another sampling cycle is
not initiated.
3- Backlight is always on. This choice will quickly run down a
battery.
ENTER PASSWORD
__ __ __ __ 04:30:02
Creates a password to stop unauthorized access. There are 2
options:
A. Press <ENTER> to accept no password - 0000 (default
shown)
B. Enter a 4-digit number at the prompt and press <ENTER>.
The user will be prompted to verify the password. Enter the
same 4 digits and press <ENTER>. This sets the password.
RECORD the numbers. To change a password, enter *99
mode and input the 4 digit numeric password at the
PASSWORD PROTECTION prompt. Press <ENTER>.
The user can now go into *99 and at the ENTER
PASSWORD prompt, create a new password.
Note: Use a TEST CYCLE setting of 0 if TEST CYCLE is to be
password protected while a program is running.
If the password is forgotten, call the Manning Service Department at
(800)-863-9337.
After finishing the Configuration Mode, the sampler will return to the Sampler Ready prompt and the current
time will be displayed. Configuration is now complete, and the sampler is ready for programming.