Manning YB8, Operating And Instruction Manual

Page: 23 / 121

MODEL YB8 INSTALLATION AND OPERATION
Bottle Installation
April 1999/Manning Environmental Inc.
Page A-13
Figure 20 -
1 Liter and 1/2 Liter
Bottles Installed in Suspension
Plate
Figure 21
- 1 liter
(left) and 500ml
(right) bottles
One Liter and Half-Liter Plastic Bottles
1. Insert the bottles through the larger
part of the hole in the suspension
plate.
2. Place the bottles so the smaller angled
part of the bottles points in toward the
middle of the case. Snap each bottle
into place in the smaller part of the
hole. Be sure the bottles are held
below the threaded section.
3. Secure bottles by placing the o-ring around them
.
Spout Position
If the suspension plate was removed from the refrigerator,
replace it. Place the spout over the last bottle in the series,
since the first action of the sampling cycle is a spout
advance.
Installing The Sampler
Install the sampler on a firm, level surface adjacent to the sampling point. If the sampler is installed outdoors,
consider enclosing it in a shelter or under some sort of protection. This will improve the performance and life
of the unit. The Manning Parts Department can supply an optional full-size NEMA 3R insulated fiberglass
enclosure designed for this purpose.
Connecting Power
The YB8 sampler was designed with components which operate on 12 VDC power. Recognizing
that 115 VAC power has to be available to run the refrigerator, the sampler takes advantage of the
constant supply by employing an AC/DC converter to provide power to the system. The converter is
located inside the electronics enclosure. It comes equipped with a power cord, but it can be hard
wired if desired. A power switch, which controls flow of current to the controller and peristaltic
The bottles can be installed with the suspension plate in the refrigerator, or the plate can be removed,
the bottles installed, and the plate positioned back in the refrigerator.
Follow the instructions below fro the type of bottles being installed.