8-88
Published 01-14-2021 Control # 707-01
CARRIER
TMS9000-2 SERVICE MANUAL
5.
Tag and disconnect the hydraulic lines to the cylinder
end of the extension cylinder. Cap all lines and fittings.
6.
On the side of the outrigger housing, remove the two
setscrews from the side adjustable wear pads and back
off the wear pads from the housing (Figure 8-86).
7.
Remove the bolt, washer, lockwasher and nut securing
each hydraulic tube to the outrigger housing.
8.
Remove the cotter pin and clevis pin securing the rod of
the extension cylinder to the outrigger housing.
9.
After attaching a suitable lifting device of straps or belts,
instead of chains to prevent damage to the bottom
edges of the outrigger beam, pull the outrigger beam out
of the outrigger box, re-adjusting the lifting attachment to
prevent the beam from tipping.
WARNING
Death or Injury Could Occur!
Make sure that any blocking material used is capable of
supporting the weight of the outrigger beam. Do not allow
it to tilt or slide.
Fo
r
Reference
Only
