Grove
Published 01-14-2021 Control # 707-01
4-23
TMS9000-2 SERVICE MANUAL
SUPERSTRUCTURE
4
12.
Install wear pads (44) and plates (45).
13.
Install sliders (36) and plates (37, 38).
14.
Install the guide pilots (39).
15.
Install the sliders (33) and plates (34, 35).
16.
Place the wear pad (29) on the section and insert eight
strips (32) inside.
17.
Secure the wear pad (29) with the plate (30).
18.
Install the opposite wear pad (59), strips (32) and plate
(30).
19.
Assemble the lubrication hoses (53, 54, 55, 58) and
connect to the wear pads (29, 59).
20.
Attach the thin nuts (57) and pipe unions (56) to the
lubrication hoses and secure the hoses to the tabs
inside the section.
21.
Install the locking unit assemblies (26, 27).
22.
Insert Section 5 completely into Section 4.
23.
Insert Section 4 into Section 3 just far enough to
measure the gaps between the sliders and wear pads
and Section 3. The gaps should be no greater than 1.52
mm (0.06 in). Adjust the gaps by adding or removing
plates or using thicker or thiner sliders and wear pads.
24.
Insert Section 4 into Section 3 half way.
FIGURE 4-21
9521
Telescope Section 3 Assembly
Fo
r
Reference
Only
