Ref.: MEL-WA(3D HCV) - OM Ver.1.7
3
2.3.
SAFETY INSTRUCTIONS FOR OPERATION
1.
Read the Operating manual thoroughly.
2.
Only permit qualified personnel to operate, maintain or service the Aligner.
3.
The operator should have thorough understanding of the vehicle systems being
serviced & sufficient knowledge on the operation & safety features of alignment.
4.
Always keep the Aligner and the surrounding work area clean and free of Tools,
Parts, Debris, and Grease etc.
5.
Do not operate, if the equipment has been dropped or damaged until it has been
examined by qualified service personnel.
6.
Do not operate the equipment with damaged / twisted power cord.
7.
Do not operate the equipment under direct sunlight. Even reflected
sunlight from Target plate reaching the camera will result in erratic
readings and the system will display
Target error
indication.
8.
Air blowing equipments like Pedestal Fan, Room heater should not be in the
close proximity of Camera assembly & targets as it will disturb the Beam & affect
the reading stability.
9.
Always unplug the equipment from electrical outlet when not in use. Do not pull
on the cable; always pull the plug directly out of socket.
10. Handle the Target plates carefully. Rough handling / shocks may cause damage.
Ensure the patterned surface of Target plates is always clean from dust &
scratches. Use soft & dry cloth to clean the surface. Prevent deep scratches on
the reflecting surface of the target plate.
11. Do not move or turn the equipment while the System is in power up condition.
12. Ensure the Rotary plates are locked with locking pins before parking the vehicle.
13. Ensure gap filling spacers are located on Rotary plates before parking vehicle.
14. Do not keep heavy objects over the equipment.
15. Do not hammer or hit any part of the equipment with Tools when the equipment
is in ON condition.
16. Ensure that the Caster wheel of Main cabinet is locked while it is stationary.
While moving the Cabinet, release the lock & then proceed. Do not lean over the
Cabinet as it may disturb the assembly & cause damage to personnel / product.
17. Keep hair, loose clothing, fingers & all parts of body away from rotating / moving
parts.
18. Always wear Eye Safety glasses & Ear plugs (noisy environment >70db) while
doing under chassis adjustments / corrections from the Alignment pit or
Alignment lift to avoid oil drops / dust particles falling on to Eye. Use hand
Gloves to avoid fire hazards from the hot surfaces of vehicle.
19. Always comply with the applicable accident prevention regulations.
2.4.
SAFETY INSTRUCTIONS FOR SERVICING
1.
Inspect the Wheel aligner on daily basis.
2.
Only authorized personnel are allowed to service the Aligner.
3.
Turn OFF MCB & unplug the Aligner before doing any maintenance or repair.
4.
Only certified engineers are allowed to service the parts of the equipment.
5.
Do not remove / disable / override any safety device / assemblies.
6.
Third party products should be serviced only by the OEM
‟s authorized service
personnel. Refer the respective service policies provided.
7.
The use of cleaning agents which attack coating or sealing materials could result
in equipment damage.
8.
Use Manufacturer spare parts only to guarantee the reliable function and to
ensure safety of the equipment.
Alignment done
in sunlight will
lead to
Target
error
indication