Repair Manual MAN-00
190
THAR
CRDe
BS-IV
MAY
2012
/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
COOLANT – REPLACE
Coolant
–
MAXIMILE Coolant (Pre-mixed)
Capacity –
10 Lit.
COOLANT – REPLACE.
Refer illustrations shown A, B and C.
1.
Open the radiator cap
2.
Remove the drain plug on the Radiator bottom
[C]
and Engine block
[B]
3.
Drain the coolant and collect in drain tray.
4.
Refit the drain plugs & fill new coolant in radiator
5.
Check all the hoses & clips for leakage and correct fitment.
6.
Start the engine and run at approx.
1200rpm for 2-3 min.
7.
Check coolant level in radiator and add coolant as per requirement.
8.
Fill coolant in the coolant recovery tank up to MAX level
9.
Refit the radiator cap.
10.
Start the engine and run at approx.
1200rpm for 2-3 min.
11.
Check coolant level in radiator and coolant recovery tank and add as required
•
Never remove the radiator cap when the engine is hot.
•
Never mix MAXIMILE coolant with water. It is pre-mixed.
•
Replace coolant at every 40000kms.
•
If the activity is done on a 2 post lift, ensure that the LSPV spring is disconnected before
lifting the vehicle. After lowering, re-connect the LSPV spring and ensure that the setting
height is correct.
A
B
DRAIN PLUG ON ENGINE BLOCK
DRAIN COCK ON RADIATOR
C
Page 81
