Maguire Products, Inc.
Rev. December 18, 2019
– ULTRA-1000 Touchscreen
18
ULTRA By Maguire
- Ultra Low Energy Dryer
Dryer Internal Assembly
If your Dryer has been shipped with the Retention Hopper Assembly and
the Vacuum Tank Assembly together as one shipment (sections A and B
in the diagrams), then the Dryer Internal Assembly instructions are not
necessary as they are pre-assembled.
Remove the rear panels of Retention Hopper Assembly (A) and Vacuum Tank Assembly
(B) to gain access to the connections that need to be made within the enclosure.
Summary of internal connections:
•
Heating Hopper Heater connected to blower outlet.
•
Power Junction Box Plug
•
Purge Air Solenoid Valve Electrical Plug
•
Electrical Field Joints (Color Coded)
•
¾ inch Purge Line
•
5/32 inch air lines
Install the Heating Hopper Heater
The Heater a polished steel 6-inch cylinder that is pre-
wired and secured within the cabinet during shipping.
This heater must be attached to the outlet of the blower
using the attached 6-inch clamp. First loosen the clamp
attached to the blower’s output. Leave the clamp on the
blower. Then remove the shipping material securing the
Heating Hopper Heater.
Carefully rest the Heater on top of the blower output so
that the heater rests directly on the blower’s 6-inch
output. Tighten the clamp firmly to secure the Heater to
the blower.
