Section 6 – RCP Programming (Continued)
48
Enter the Access Code (must be set for system to work):
Screen switch operation.
The screen switches are labeled from left to right “A”, and “B”. They are numbered from left to right 1 to 8. The
black rectangle to the bottom is “OFF” or “0”; the green rectangle to the top is “ON” or a “1”. Clicking the grey
rectangle will cause the switch to toggle. There is also a box which shows the decimal value of the binary number
entered. Some receiver types will show the access code as a decimal number. That number can be entered here.
See Section 5.1. Access Code Programming for details on access code programming. There should be a label
either on the receiver or the old transmitter showing the access code; it should be numbered A1 through A8 and
B1 though B8. Find this number and tap the respective switches on the screen. If you cannot find a label with
access code information, copy directly from the access code dip switches in your transmitter or receiver, being
careful to match the designation and switch position as they do vary from model to model.
Control Configuration (2 speed only)
The transmitter can be programmed for custom control configurations using the control function. These
configurations correspond to the wiring diagrams in Section 6 of the
intele
Smart receiver manuals. Simply select
the setting that matches the title of the desired wiring diagram.
Main/Aux (2 speed only)
This menu will only appear if a special control configuration (above) is not selected. This menu defines the
function of the auxiliary buttons. The “Aux” setting is used for a standard three motion crane. The top three
auxiliary buttons will be active. “Motor” is used for a four motion crane. The button just above the E-stop will
serve to select between the main and aux. motors. The tandem check box will appear when this is selected. If you
want to be able to operate both hoists at the same time, check tandem. Select allows the system to operate with
select relays. Again, check tandem if you want to operate both Hoist/trolleys together. The invert check box will
also appear. This function is rarely used and this box should normally not be checked. Consult Field Service (1-
800-288-8178) if you are unsure if you need this function.