Section 5 – Programming (Continued)
30
L.
Go to the appropriate Section for your system.
5-3.3 2-Speed telePendant, Page 33.
5-3.4 3-Speed telePendant, Page 36.
5-3.5 3-Speed 10K Pendant, Page 38.
5-3.3.
2-Speed telePendant Programming.
NOTE
IF REPLACING A MEMBRANE OR PENDANT TRANSMITTER, YOU CAN COPY THE SWITCH SETTINGS ON
THE EXISTING TRANSMITTER.
Membrane:
Copy Switch 3 (all positions) settings on the Membrane transmitter to S3 on the PDA.
Pendant:
Copy Switch 3 (positions 1, 2, 3 and 8) settings on the Pendant transmitter to S3 (positions 1, 2, 3 and 8
respectively) on the PDA. Copy Switch 4 (positions 5, 6 and 7) settings on the Pendant transmitter to S3 (positions 5, 6 and
7 respectively) on the PDA.
If Switch 4 on the Pendant transmitter has positions 1 and or 2 Switched ON see the write-up
on Main/Aux Menu below. If SW4 position 3 is switched “ON” un-check Tandem box on PDA. If SW4 position 4 is
switched “ON” check Invert box on PDA.
M.
S3 Programming (mot required for an inteleSmart receiver).
S3 Positions 1-3 Repositioning of telePendant Transmitter Motion Switch Functions (standard configuration all
“OFF”).
S3 positions 1 through 3 can change the functional positions of the switches controlling hoist, trolley and bridge. This
reconfiguration does NOT affect receiver wiring. As these switches are changed the motor controls are moved.
Standard, Motor 1 is H (Hoist), Motor 2 is T (Trolley), and Motor 3 is B (Bridge). The standard configuration (all switches
OFF) starts at the top right hand pair of buttons on the transmitter, which are for Motor 1. The middle two right hand pair
of buttons are for Motor 2. The bottom pair on the right is Motor 3. This is indicated the display “Switch config: H,T,B.”
The order of Hoist, Trolley and Bridge will vary as S3-1 to 3 switch positions is changed. Toggle the switches sequentially
till you see the order you need. There are six possible combinations.
S3 Position 4 and 8 Time-out-timer Disable (normally turned “OFF”).
Disables the transmitter time-out-timer if turned ON. If the time-out-timer is active, the length of time for time out can be
selected for numbers of minutes till shut down. The minutes are selectable in one-minute steps from 1 to 10 and five
minutes steps up to an hour. Tap on the “Timer” arrow and scroll down through the number of minutes and tap on the
desired number.
Positions 5-7 Special Crane Control Configurations (standard all “OFF”).
The wiring section of the manual for receiver shows all the different crane configurations and the switch positioning
needed to achieve them. The standard transmitter comes with the output standard output configuration. For special crane
control configurations program S3 positions 5-7 to match the programming information shown for the respective wiring
diagram. When any of the special crane configuration switches is turned ON, the words “Crane control enabled” appears
on the display and Main/Aux disappears.
Position 8, Same as Switch Position 4. See write up for switch 4 above (normally turned “OFF”).