Section 5 – Programming (Continued)
33
5-3.4.
3-Speed
telePendant
Programming .
M.
Motor Menu for controlling the “Programmable Motor Control” Push Button.
(For a three motor crane use “3”, for standard five or four motor use “5 “).
For
three motor system
this push button is nonfunctional (Motor “3”). This configuration is typically used with the
intele
Smart 16 output Receiver.
For
five motor system
this button controls main and aux motors such as a hoist and trolley (see Section 4. Operation, for
details on the operation of this button). To program a fourth or fifth motion select (Motor “5”). This five motor application
can only be used with the
intele
Smart 24 output Receiver. The Programmable Motor Control push button becomes a switch
to toggle between “A” and “B” or both, where “A” and “B” are main and auxiliary motors respectively. The main motor
outputs are motor 1 and motor 2 and the auxiliary motor outputs are motor 4 and 5 respectively.
Tandem for Hoist, Trolley or Bridge (normally not checked).
This function appears if a four or five motor system function is chosen. Normally the box is not checked, meaning “Both A
and B” operation is enabled (both MAIN and Aux can be ON at the same time). Removing the check from the box by
tapping on it disables the “Both” function (“A” and “B” will not come ON at the same time). This function maps to
Pendant Switch 4 position 3; if SW4 position 3 is switched “ON” check Tandem box on PDA.
This completes the tele
Pendant
3-Speed programming; when completed with the above, tap “Save”.
Save will take you back to the initial start screen. At this point select another Bank to program or
go to Section 5-4.
Saving, Downloading, Reading the Programs and Other PDA Functions on page 40.
E-STOP
3 speed tele
Pendant
Transmitter.
Programmable
Motor Control Push Button with
Indicators
A B