Section 5 – Programming (Continued)
27
Setup Bank Programming Screen.
After seleting a Bank, the number of the Bank will appear at the top of the screen.
The respective screens appear as shown below (the 2-Speed screen is shown first):
NOTE
IF YOU HAVE AN INTELESMART RECEIVER FREQUENCY AND ACCESS CODES CAN EASILY BE
DOWNLOADED DIRECTLY INTO YOUR PDA.
E.
Downloading Parameters from an inteleSmart receiver.
Select the Bank you wish to program, cycle the power to the
intele
Smart receiver. Within the first 10 seconds of the
receiver turning ON, point the PDA at the receiver’s IR port (see receiver manual for location) and tap the “Rx Setting”
button on the PDA. If the frequency and Access Code will be downloaded, skip the next two steps.
F.
Select a Frequency (Must be inputted for system to work):
There should be a label either on the receiver or the transmitter being replaced listing frequency, it should be a channel
number between AK01 to AK20. Find this number and tap the “Freq” arrow and select that channel number.
2-Speed telePendant Bank Programming Screen.
System
10K
Freq
AK01
Setup Bank #
A1
Receiver access code
1
0
B1
1
0
S3-1
1
0
Timer
Switch conf.: H,T,B
Main/Aux Aux
only
Save
Cancel
Multibox
Auto Turn Off Active ESTOP
RX Setting
15
3-Speed 10K Pendant and 3-Speed
telePendant Bank Programming Screen.
Multibox
Active ESTOP
RX Setting
15
Freq
AK01
Setup Bank #
A1
Receiver access code
1
0
B1
1
0
Timer
Save
Cancel
E. Select a
Frequency
Motor
5