Section 4 – Operation
13
4-1.
Transmitter Buttons.
ON/OFF
On the
tele
Pendant Transmitter ON and OFF is the same button. This button toggles between
turning the transmitter ON and then sending the ON command to the receiver and sending the OFF
command to the receiver and then turning the transmitter OFF. Press and hold the button for one full
second to turn the unit ON.
Labels are provided for the auxiliary buttons and the labeled pushbutton boots can be unsnapped and
moved to reflect the desired labeling. Custom labels are available from Telemotive.
NOTE
IN THE
tele
PENDANT THE TRANSMITTER DOES NOT TURN ON TILL THE ON PUSH BUTTON
IS RELEASED AFTER BEING DEPRESSED FOR ONE SECOND. THE OFF FUNCTION IS
IMMEDIATE UPON DEPRESSING THE ON/OFF PUSH BUTTON.
E-STOP – Stops
all equipment movement and disables all functions except Alarm. Reset the system for
normal operation by turning the transmitter “OFF” then “ON”. Use for emergencies only. (NOT FOR
NORMAL SHUT DOWN).
NOTE
ON THE
tele
PENDANT TRANSMITTER THE USER CAN CHOOSE AND CUSTOM LABEL THE
FUNCTIONS FOR A SPECIFIC MOTOR. THE FUNCTIONAL DESIGNATIONS SHOWN BELOW
ARE COMMON AND TRADITIONAL DESIGNATIONS.
Common Designations Listed Below:
Motor 1 Dir 1, UP
– Selects hoist movement in the UP direction speed one (first switch position), speed
two (second switch position), or speed three (third switch position if so equipped).
ON/OFF
&
Low Battery Indicators
Figure 4-1. 2- and 3-Speed
tele
Pendant
E-STOP
Motor 1
Dir 1
Dir 2
Motor 2
Dir 1
Dir 2
Motor 3
Dir 1
Dir 2
Programmable
Motor Control and Select Indicators
AUX 1
AUX 2
AUX 3
AUX 4
AUX 5
AUX 6
Auxiliary
Controls
A B
ON/
OFF