Section 6 – RCP Programming (Continued)
46
The Bank password can be disabled during initial programming by the RCP software. To disable password
protection, uncheck the box next to the phase “Use bank password”. Disabling the Bank password is not
recommended unless the operator has access and visibility to all possible cranes controlled.
WARNING
DISABLING THE PASSWORD FUNCTION PUTS THE SYSTEM IN ACTIVE BANK SELECT. THIS
ALLOWS THE CRANE OPERATOR TO SWITCH BETWEEN BANKS QUICKER. THE OPERATOR IN
THIS MODE MUST BE AWARE AND RESPONSIBLE FOR ALL POSSIBLE CONTROLLED CRANES.
FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND
DAMAGE TO EQUIPMENT
.
Enable a Bank (at least one must be enabled).
When done with the password section, select the number of the Bank(s) you wish to use and check the cell labeled
with the appropriate Bank number.
You do not have to use all Banks and you do not have to use them in order.
Even after programming a Bank you can turn it back “OFF”. A programmed Bank will not lose its programming
by turning it “off”. By turning ON and OFF Banks you can easily save certain transmitter configurations in the
transmitter to turn them on at a later time with the RCP software without having to completely reprogram them.
Unit ID name
Is retrieved from the transmitter by using the receive button. This is the name and ID that was assigned to the
transmitter on initial programming.
Custom Name
This allows the user to create a name to identify the transmitter. The unit ID name will be overwritten by the
custom name.
Bank Programming Screen.
Select the bank you wish to program.