Section 6 – RCP Programming (Continued)
42
6-3.
Multibox.
Multibox Operation. (Optional, for 10K receivers with Multibox option only).
Do not use on inteleSmart Receivers
.
Use Group Code feature,
see
intele
Smart Receiver Manual
.
WARNING
IF YOUR RECEIVER WAS NOT ORDERED WITH MULTIBOX DO NOT ATTEMPT TO PROGRAM
MULTIBOX IN THE FIELD. TELEMOTIVE MUST COORDINATE ACCESS CODE ASSIGNMENTS WITH
THE TRANSMITTERS PRIOR TO ENABLING MULTIBOX. PLEASE CONTACT TELEMOTIVE IF YOU
NEED TO ADD MULTIBOX. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS
INJURY OR DEATH AND DAMAGE TO EQUIPMENT.
WARNING
IF YOUR UNIT HAS MULTIBOX DO NOT ATTEMPT TO PROGRAM ADDITIONAL TRANSMITTERS IN
THE FIELD. TELEMOTIVE MUST COORDINATE ACCESS CODE ASSIGNMENTS WITH THE NEW
TRANSMITTERS PRIOR TO EXPANDING MULTIBOX. PLEASE CONTACT TELEMOTIVE IF YOU
NEED TO ADD ADDITIONAL TRANSMITTERS. FAILURE TO FOLLOW THIS WARNING COULD
RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO EQUIPMENT.
Many receivers have Multibox capability that allows up to 8 transmitters to access a single system. Only one
transmitter may control the receiver(s) at a given time. Access is on a first come first serve basis. Once a
transmitter has gained control, another transmitter may not access the receiver(s) until the controlling transmitter
relinquishes control by transmitting an OFF command to the receiver(s) or the receiver(s) times out due to
inactivity.
The first transmitter to send an ON command after the receiver has been released will then gain control of the
receiver(s). The number of transmitters (up to 8 depending on receiver configuration) allowed to control the
receiver(s) is dip switch selectable on the Receiver Board.
NOTE
THE DESIRED MULTIBOX TRANSMITTERS MUST HAVE CONSECUTIVE ACCESS CODES
BEGINNING FROM THE FIRST ACCESS CODE.
6-4.
Programming.
6-4.1.
telePendant Programming.
Read Section 4-5. Additional
tele
Pendant Operational Features to familiarize you with the features listed below.
The
tele
Pendant transmitter is programmed using the RCP (Radio Control Programmer) software. RCP can be
ordered from your Magnetek distributor.
Magnetek RCP software
is user friendly and is intended to provide plain language descriptions of all transmitter
functions and options. Help is provided for each function at the bottom of the RCP screen. The RCP software
allows you to select frequency, access code, time-out-timer settings, switch arrangement and crane configuration
as in other Telemotive transmitter products. Follow the steps below: