Section 6 – RCP Programming (Continued)
47
This will open the bank programming screen.
NOTE
IF YOU HAVE AN INTELESMART RECEIVER, FREQUENCY AND ACCESS CODES CAN EASILY BE
DOWN LOADED DIRECTLY INTO THE RCP SOFTWARE.
Downloading Parameters from an inteleSmart receiver.
Select the Bank you wish to program, and then cycle the power to the
intele
Smart receiver. Within the first 10
seconds of the receiver turning ON, point the IR Adapter at the receiver’s IR port (see receiver manual for
location) and click the “Rx Setting” button on the RCP programming screen. The frequency and Access Code will
be downloaded; if successful, skip the next two steps.
Select a Frequency (must be set for system to work):
There should be a label either on the receiver or the transmitter being replaced listing frequency, it should be a
channel number between AK01 and AKA08. Two additional channels, AK38 and AK50, may also be used. Find
this number and tap the “Freq” arrow and select that channel number.