Section 4 – Operation (Continued)
19
telePendant Time-Out-Timer Function.
The transmitter has a time-out timer and the default condition is 15 minutes. Upon timing out the
transmitter will send an OFF command to the receiver if Auto Turn Off is active. The transmitter time-out-
timer function is programmable in minute increments to up to and including 15 minutes. After that it is
programmable in five-minute increments up to and including one hour. Infinite time-out (none) is also
selectable. The time-out-timer measures the time since the last pushbutton stroke and is continuously reset
by any pushbutton activation.
4-6.
Battery Replacement.
telePendant Battery Replacement.
On the
tele
Pendant if the yellow battery indicator light starts to flash replace the battery at the earliest
opportunity. If the light is on solid replace the battery immediately.
NOTE
THERE IS NO NEED TO RUSH BATTERY REPLACEMENT. THE PROGRAMMING IN THE
TELE
PENDANT WILL
NOT
BE LOST BY REMOVAL OF THE BATTERY OR PROLONGED LOSS
OF POWER.
Turn the transmitter OFF, loosen the two coin-screws on the bottom of the unit with a small coin and
remove the bottom door. (See below). Pull out the battery holder until the batteries can be accessed. Do not
pull hard on the battery holder as it is attached to the logic board by a cable.
Figure 4-3. telePendant Battery Replacement.
Battery
Connector
Battery
Press Tab
Pull on
connector housing
Battery
Figure 4.4 Disconnecting the battery.
Locking Tab