![background image](http://html1.mh-extra.com/html/magnetek/gpd-315/gpd-315_technical-manual_3602605004.webp)
- ii -
CAUTION
Parameter
n012 must be set to proper motor voltage. Drive leaves factory
with this parameter set for “ 400 ” volts.
CAUTION
Always ground the GPD 315 using its ground terminal ( ) (near the main
circuit output terminals). See paragraph 1.4A, “Grounding”.
Never connect main circuit output terminals T1 (U), T2 (V) & T3 (W) to AC
main circuit power supply.
CAUTION
When drive is programmed for auto-restart ( n082 = " 1 " thru " 10 "), the
motor may restart unexpectedly — personal injury may result.
IMPORTANT
Wiring should be performed only by qualified personnel.
Always ground the GPD 315 using ground terminal ( ). See paragraph 1.4C, “Grounding”.
Verify that the rated voltage of the drive matches the voltage of the incoming power.
Never connect main circuit output terminals T1, T2, and T3 to AC main circuit power supply.
All parameters have been factory set. Do not change their settings unnecessarily.
Do not perform a “HIPOT” or withstand voltage test on any part of the GPD 315. Equipment uses
semi-conductors and is vulnerable to high voltage.
The Control PCB employs CMOS ICs which are easily damaged by static electricity. Use proper
electrostatic discharge (ESD) procedures when handling the Control PCB. Never touch the printed
control board (PCB) while the main input power is turned on.
Any modification of the product by the user is not the responsibility of MagneTek, and will void the
warranty.
Do not remove the Digital Operator or change dipswitch SW2 or rotary switch SW1 unless the main
input power is turned OFF.
Summary of Contents for GPD 315
