VICON
MANUAL X435-493
INSTRUCTIONS FOR
I
I
I
INSTALLATION AND OPERATION
MODEL
LIGHT-DUTY WEATHERPROOF
PAN-AND-TILT DRIVE
1. INTRODUCTION
The information in this manual covers the installation,
operation, and maintenance of Model
1 and
Pan-and-Tilt Drives. Throughout this
manual, the term
refers to both models
unless otherwise stated.
This unit should be installed only by a qualified service
technician using approved materials and wiring prac-
tices in conformance with the national, state, and local
electrical codes. Read these instructions through com-
pletely before beginning installation.
The
is a light-duty weatherproof
tilt drive with
The unit is designed to handle
loads up to 10 pounds (4.5 kg) when mounted in either
an upright or inverted position. Operational stability
with minimum coast is provided by drive motors with
instant start-stop characteristics. Drive trains are con-
structed with output gears that do not require field
lubrication. A low noise level is maintained by
speed, high-torque motors. The pan-and-tilt motors are
impedance protected. A molded gasket protects the unit
from moisture.
The
is equipped with factory-installed
position-feedback potentiometers for preset-position
operation. When used with an appropriate preset control,
this allows position feedback operation of the unit.
Designed for use with the
Wall Mount, the
accommodates most
and smaller
camera/lens combinations. The unit may be mounted
directly to a flat surface when used with a
Square Base. The unit requires 24 VAC input voltage.
The
1 may be energized using an appropri-
ate control unit with or without an appropriate relay box.
Model
and
are listed
under UL standard 1409.
2. INSTALLATION
2.1 Unpacking and Inspection
All Vicon equipment is tested and inspected before leaving
the factory. It is the carrier’s responsibility to deliver the
equipment in the same condition as it left the factory.
2.1.1 INSPECTION FOR VISIBLE DAMAGE
Immediately inspect the cartons upon delivery. On all
copies of the carrier’s freight bill, make a note of any
visible damage.
Make sure the carrier’s agent (the person making the
delivery) signs the note on all copies of the bill. If the agent
does not have claim forms, contact the carrier’s office.
Product specifications subject to change without notice.
Vicon part number 8006-8435-06-00
INDUSTRIES INC. 89 ARKAY DRIVE, HAUPPAUGE, N.Y. 11788
l
TEL:
(2288)
l
FAX: 516-951
(2288)
TOLL FREE: I-800-645-91 16 . UK:
. INFOFAX: I-800-287-1207
l
WORLD WIDE WEB:
