![background image](http://html1.mh-extra.com/html/magnetek/flex-ex/flex-ex_instruction-manual_3604703078.webp)
Page 77
10) Press “
→
” button to enter TAC setting
11) Press READ button to transfer all access cards info into the IR
programmer for further programming. If the screen shows “READ OK” the
transfer is completed.
12) After entering the TAC setting the first screen you see is either “EMPTY”
(no access cards) or “_ CARDS” (number of access cards) + “DEL_ALL”
(delete all) command.
13) Select “DEL_ALL” by pressing “
→
” button one time if you want to delete all
access cards from the system. Press “
→
” button again to delete.
14) Press “
↑
” and “
↓
” button if you want to program the access cards.
15) “CARD 1” shown on the screen is always the last access card scanned
into the transmitter.
16) Press “
↑
” and “
↓
” button to select which access card to program and then
press “
→
” button to enter.
17) A mix of alphabets and numbers shown on the second line below the
access card number is the access card ID number.
18) The next line (S1234567) is the transmitter function. “S” is for START
(access card required after transmitter power on), “1” for PB1, “2” for PB2,
“3” for PB3, etc… The third line (89101112) is for PB8 through PB12.
19) Press “
→
” button to go to the first digit from the left and press “
↑
” and “
↓
”
button to assign or un-assign. Assigned is represented by black color
background with white “S” or number 1~12.
20) When “S” (START) is assigned on one of the access card, the same “S”
START function on all other access cards is also assigned automatically.
The pushbutton functions can be individually assigned.
21)
Press
“
→
” button to go to the next column to the right and redo step 19.
22) Program other access cards by pressing the “BACK” button until the
cursor is shown next to “CARD # and redo step 16.
23) When all access cards are programmed, use the IR programmer to
transfer all access card info back to the transmitter by pointing the infrared
sensor towards the transmitter Status LED location within a distance of no
more than 10cm and press the “WRITE” button. In order for the
transmitter to receive TAC info back from the IR programmer it must be in
the TAC mode as well (refer to step 1 through 4). If the screen shows
“WRITE OK” the transfer is completed.
24) Exit Program TAC by pressing the “BACK” button until the cursor is
shown next to “TAC”.
Summary of Contents for FLEX EX
