Magnetek FLEX EX, Instruction Manual

Page: 14 / 120

Page 13
5.13 Program LED3 Feedback (TX)
1) Press “ → ” button to enter Feedback setting.
2) Press “ ↑ ” and “ ↓ ” button to select Off, Input number or Output number.
3) When “Input” is selected, press “ → ” button and then “ ↑ ” and “ ↓ ” button to
select input number that the external source is connected to (IN1 ~ IN4).
4) When “Output” is selected, press “ → ” button and then “ ↑ ” and “ ↓ ” button to
select which output relay to feedback to LED3 (K1 ~ K24).
5) Select “Off” if no feedback is required.
6) Exit Program Feedback by pressing the “BACK” button until the cursor is
shown next to “LED3”.
7) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EX2 settings.
5.14 Program LED4 Feedback (TX)
1) Press “ → ” button to enter Feedback setting.
2) Press “ ↑ ” and “ ↓ ” button to select Off, Input number or Output number.
3) When “Input” is selected, press “ → ” button and then “ ↑ ” and “ ↓ ” button to
select input number that the external source is connected to (IN1 ~ IN4).
4) When “Output” is selected, press “ → ” button and then “ ↑ ” and “ ↓ ” button to
select which output relay to feedback to LED4 (K1 ~ K24).
5) Select “Off” if no feedback is required.
6) Exit Program Feedback by pressing the “BACK” button until the cursor is
shown next to “LED4”.
7) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EX2 settings.
5.15 Program Infrared START (TX)
1) Press “ → ” button to enter Infrared Start setting.
2) Press “ ↑ ” and “ ↓ ” button to select Off or IRS.
Select “OFF” to disable infrared START function.
Select “IRS” to enable infrared START function.
3) Exit Program Infrared START by pressing the “BACK” button until the cursor
is shown next to “IR Mode”.
4) Press “ ↓ ” button to go to the next Infrared START setting.
5.16 Program Infrared START ID Code (TX)
1) Press “ → ” button to enter Infrared START ID code setting.
2) Press “ ↑ ” and “ ↓ ” button to set the 3-digit ID code as a whole or…
3) Press “ → ” button to go to the digit on the left.
4) Press “ ↑ ” and “ ↓ ” button to change numeric value.
5) Press “ → ” button to go to the next digit to the right and repeat step 4.
6) Press BACK button to go back to step 2.
Make sure the infrared module on crane is set to same ID code as the transmitter.
Select “000” disables the ID code function hence any types of infrared modules can be used.
7) Exit Program Infrared START ID Code by pressing the “BACK” button until
the cursor is shown next to “IR ID”.
8) Press “ ↓ ” button to go to the next Infrared START setting.