Magnetek FLEX EX, Instruction Manual

Page: 54 / 120

Page 53
9.7 Program RF Power (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “
→ ” button to enter RF Power setting.
3) Press “ ↑ ” and “ ↓ ” button to change RF power (0.1mW ~ 10mW).
4) Exit Program RF Power by pressing the “BACK” button until the cursor is
shown next to “RFpower”.
5) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EP-H settings.
9.8 Program Pushbutton Speed (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “
→ ” button to enter Pushbutton Speed setting.
3) Press “ ↑ ” and “ ↓ ” button to change percentage value (25, 50, 75, 100).
4) Exit Program Pushbutton Speed by pressing the “BACK” button until the
cursor is shown next to “PB SPEED”.
5) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EP-H settings.
9.9 Program Pushbutton Functions (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “
→ ” button to enter Pushbutton Function setting.
3) Press “ ↑ ” and “ ↓ ” button to change pushbutton function as a whole or…
4) Press “ → ” button to go to the digit on the left.
5) Press “ ↑ ” and “ ↓ ” button to change numeric value.
6) Press “ → ” button to go to the next digit to the right and repeat step 5.
7) Press BACK button to go back to step 3 or 4.
8) Exit Program Pushbutton Functions by pressing the “BACK” button until
the cursor is shown next to “PB FUNC”.
9) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EP-H settings.
Not yet available
9.10 Program Password (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “
→ ” button to enter Password setting.
3) Press “ → ” button to go to the 1
st
digit on the far left.
4) Press “ ↑ ” and “ ↓ ” button to change numeric value.
5) Press “ → ” button to go to the next digit to the right and repeat step 4.
6) Press BACK button to go back to step 3.
7) Exit Program Password by pressing the “BACK” button until the cursor is
shown next to “PASS WORD”.
8) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EP-H settings.
Only PB1 through PB4 are used when using the password function. Numeric
value “1” represents PB1, “2” represents PB2, “3” represents PB3 and “4”
represents PB4.
Setting “1111” → Password function disabled (manufacture preset)