Magnetek FLEX EX, Instruction Manual

Page: 13 / 120

Page 12
5.10 Program Transmitter Inactivity Timer (TX)
1) Press “ → ” button to enter Transmitting Timer setting.
2) Press “ ↑ ” and “ ↓ ” button to select “_M” for minutes/seconds or “ON” for
constant on.
3) When “ON” is selected, press “ → ” button and then “ ↑ ” and “ ↓ ” button to
select “+START” or “+ANY”.
4) When “_M” is selected, press “ → ” button to go to the digit on the
left and press “ ↑ ” and “ ↓ ” button to select value. Press “ → ” button again to
go to the next digit and press “ ↑ ” and “ ↓ ” button to select value .
5) Press “ → ” button again to select “M” for minutes or “S” for seconds. Press
“ ↑ ” and “ ↓ ” button to select.
6) Press “ → ” button again to select “+START” or “+ANY” selection. Press
“ ↑ ” and “ ↓ ” button to select.
7) Exit Program Transmitter Timer by pressing the “BACK” button until the
cursor is shown next to “TX TIMER”.
8) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EX2 settings.
Transmitter inactivity timer is for setting receiver main relays cutoff time when the transmitter
is not in operation for a certain period of time. When set to 5 minutes (05M), the receiver
main relays are deactivated at 5.0 minutes after last transmitter operation.
Select “ON” means the receiver main relays are activated at all time unless the STOP button
is pressed down or receiver power turned off (inactivity timer disabled).
Select “+START” means after 5 minutes of transmitter inactivity you must press the green
START button to continue operation. Select “+ANY” means after 5 minutes of transmitter
inactivity press any pushbutton to continue operation.
5.11 Program LED1 Feedback (TX)
1) Press “ → ” button to enter Feedback setting.
2) Press “ ↑ ” and “ ↓ ” button to select Off, Input number or Output number.
3) When “Input” is selected, press “ → ” button and then “ ↑ ” and “ ↓ ” button to
select input number that the external source is connected to (IN1 ~ IN4).
4) When “Output” is selected, press “ → ” button and then “ ↑ ” and “ ↓ ” button to
select which output relay to feedback to LED1 (K1 ~ K24).
5) Select “Off” if no feedback is required.
6) Exit Program Feedback by pressing the “BACK” button until the cursor is
shown next to “LED1”.
7) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EX2 settings.
5.12 Program LED2 Feedback (TX)
1) Press “ → ” button to enter Feedback setting.
2) Press “ ↑ ” and “ ↓ ” button to select Off, Input number or Output number.
3) When “Input” is selected, press “ → ” button and then “ ↑ ” and “ ↓ ” button to
select input number that the external source is connected to (IN1 ~ IN4).
4) When “Output” is selected, press “ → ” button and then “ ↑ ” and “ ↓ ” button to
select which output relay to feedback to LED2 (K1 ~ K24).
5) Select “Off” if no feedback is required.
6) Exit Program Feedback by pressing the “BACK” button until the cursor is
shown next to “LED2”.
7) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EX2 settings.