![background image](http://html1.mh-extra.com/html/magnetek/chtx/chtx_instruction-manual_3584902047.webp)
Enrange CHTX Transmitter Instruction Manual
December 2017
Page 47 of 47
8.2 Optional Tether Operation Troubleshooting
8.3 Assembly and Replacement Parts
If your transmitter ever needs repair, we always recommend that you have Magnetek perform the repair. If
you need to refer to a parts list, refer to your transmitter's drawing that was included in the shipment of your
transmitter. Please contact Magnetek’s service department at 1.866.MAG.SERV for information regarding
parts and service.
Problems
Possible Reasons
Suggestions
Transmitter will not turn on
Connecting tether
cable is not installed, is
installed improperly, or
is damaged
Inspect the tether cable and confirm that
it is installed and secured correctly.
Inspect all connectors, connector
contacts and the cable jacket for
damage.
Transmitter is failing
switch scan
Be sure all switches and motions are in
the OFF position on startup.
See Section
3.3 on page 18
for more information.
Transmitter Machine
Stop switch is down or
pressed
Be sure the Machine Stop switch is
pulled up.
Transmitter will not respond
with the receiver in tether
mode
System is not in tether
mode
Make sure that the startup procedure is
initiated with the tether cable attached.
Ensure that all tether cable connections
are secure prior to startup.
The tether cable or
connectors are
damaged
Inspect the tether cable and connectors
for damage.
CAN settings are
incorrect
Verify that CAN settings match project-
specific CAN bus document.
Transmitter will not respond
with the receiver in wireless
mode
System is not in
wireless mode
Make sure that the startup procedure is
initiated with the tether cable detached.
Ensure that the startup procedure is
initiated within 300 feet (90 m) from the
receiver location.