Enrange CHTX Transmitter Instruction Manual
December 2017
Page 29 of 47
4.2.2.6 Password Enable
This setting enables or disables the requirement of entering a password into the
transmitter to enter Setup Mode.
When the disabled setting is selected, the user will go directly into Setup Mode without
being prompted to enter a password.
Magnetek strongly recommends enabling the Setup Mode password setting to prevent
unauthorized or accidental changes to parameters.
NOTE:
The unit is shipped with the password requirement enabled and using the
factory default password.
4.2.2.7 Change Password
This allows the user to change the password needed to enter the Setup Mode.
The password must consist of 4 digits.
4.2.2.8 Exit Without Save
If the user does not wish to save any of the configuration changes made, the Exit
Without Save option can be selected.
NOTE:
None of the changes will be saved upon selection of this option. The transmitter
will start up with the last saved configuration settings.
4.2.2.9 Exit With Save
Selection of this option saves all changes and exits the Setup Mode.
Upon exit, the device will start up with the new configuration settings.
