Enrange CHTX Transmitter Instruction Manual
December 2017
Page 30 of 47
5 Optional Programming with RCP
Using the optional RCP software makes programming of the CHTX easier and allows for settings to be
saved for future reference.
5.1 Access Codes
The receiver and transmitter must be programmed with the same access code to properly communicate
with each other.
5.2 Changing Receiver Access Codes
For detailed instructions on setting parameters including access codes, see the “Programming” section of
the applicable receiver manual.
WARNING
The use of RCP (Radio Control Programmer) is intended for use by authorized persons only. Changes
to any radio data value may lead to unexpected, undesirable, or unsafe operation of equipment and
furthermore may lead to equipment damage, personal injury, or even death. All equipment operators
and/or personnel should be notified of any radio data value changes that may affect operation.
WARNING
Two operational transmitters with the same access codes operating at the same time is a definite
safety hazard. Failure to follow this warning could result in serious injury or death and damage to
equipment.
WARNING
After changing the access codes on the transmitter, test the unit by turning it on and off near the
appropriate receiver. If the receiver does not respond, do not activate a function button! The transmitter
may have the wrong access code, which could move other equipment. Re-check the access code in
the transmitter and retest. Failure to follow this warning could result in serious injury or death, and
damage to equipment.
