215627
102
Revision A
$
&
%
'
Figure 5.72: R1 Rotary Disc Header Hose Support
Attachment
3.
Retrieve hydraulic hoses (A) from the header and route the
hose bundle under the windrower frame.
NOTE:
Adding anti-seize compound to the hose-holder pin will
make future removal easier.
4.
Insert pin (B) into hole (C) in the windrower frame and
place the hose bundle onto support (D).
IMPORTANT:
Route the hydraulic hoses as straight as possible, and avoid
rub/wear points that could damage the hoses. The hoses
should have enough slack to pass by the multicoupler
bracket without contacting it. To adjust the slack in the
hose, loosen the clamps below pin (B), adjust the hoses,
then retighten the hose holder.
$
$
Figure 5.73: Header Hydraulics Configurations
–
Auger/Rotary Disc/Draper-Ready
Proceed with the steps that are relevant to your windrower
configuration:
•
Auger/rotary disc/draper-ready configuration (A)
: For
instructions, refer to
Auger/Rotary Disc/Draper-Ready
Quick Coupler Connections, page 103
.
$
$
Figure 5.74: Header Hydraulics Configuration
–
Rotary
Disc-Ready with Hard-Plumbed Connections
•
Rotary disc only hard plumbed configuration (A)
: For
instructions, refer to
Rotary Disc Only Configuration
.
