215627
96
Revision A
DANGER
Check to be sure all bystanders have cleared the area.
1.
Shut down the engine, and remove the key from the ignition.
$
%
Figure 5.55: Hydraulic Center-Link
2.
Windrowers without the self-aligning center-link kit:
Remove pin (A) and raise center-link (B) until the hook is
above the attachment pin on the header. Replace pin (A) to
hold the center-link in place.
IMPORTANT:
Ensure that the center-link is positioned high enough that it
does not contact the header as the windrower approaches
the header.
$
%
&
Figure 5.56: Header Support
3.
Remove hairpin (A) from clevis pin (B), and remove the pin
from header support (C). Repeat this step on the other side
of the header.
4.
Start the engine.
$
Figure 5.57: Header Float Springs
5.
If you are lowering the header lift legs WITH a header or
weight box attached to the windrower
, proceed to Step
If you are lowering the header lift legs WITHOUT a header
or weight box attached to the windrower
, proceed to Step
to release tension from header float
springs (A).
