215627
33
Revision A
Installing rear ballast
1.
Refer to Table
to determine the amount of ballast to add to the windrower.
2.
Shut down the engine, and remove the key from the ignition.
$
%
Figure 3.40: Engine Compartment Hood
3.
Move latch (A) towards the right cab-forward side of the
windrower.
4.
Grasp louver (B), and lift the hood to open it.
$
$
$
$
%
'
&
Figure 3.41: Rear Light Bezel Attached to Windrower
5.
Remove eight hex flange bolts (A).
6.
Gently pull light bezel assembly (B) so that you can
disconnect plugs P215 (C) and P210 (D) from the back of
the red tail/brake lights inside the bezel.
7.
Remove light bezel assembly (B).
%
$
Figure 3.42: Bezel Assembly Removed from
Windrower
8.
Separate light bezel assembly (A) by removing six hex
screws (B).