215627
17
Revision A
3.2
Installing Caster Wheels
The windrower
’
s caster wheels may not have been installed at the factory. Install them now.
$
Figure 3.4: Windrower Toolbox
1.
Retrieve toolbox (A) from the storage compartment.
Remove the banding from the toolbox.
NOTE:
Use the ignition key to unlock the storage compartment.
2.
Retrieve the caster wheel hardware from toolbox (A).
$
Figure 3.5: Walking Beam Secured to Frame
3.
Remove banding and blocking (A) securing the walking
beam to the frame.
4.
Retrieve the caster wheel assemblies.
$
Figure 3.6: Lifting Windrower
5.
Using a forklift, approach the windrower from the front and
slide the forks under the frame.
CAUTION
Ensure that the forks do NOT contact fuel tank (A). Ensure that
the forks lift ONLY the windrower
’
s frame.
6.
Raise the windrower approximately 152 cm (60 in.) off of
the ground. Place suitable stands under the drive wheel
legs and the rear frame. Lower the windrower onto the
stands so that the forklift
’
s forks are partially unloaded.
