215627
26
Revision A
Figure 3.27: Walking Beam Adjustment
9.
Repeat Steps
to
to reposition the
caster at the opposite end of the walking beam. Ensure that
the casters are spaced equally from the center of the
windrower.
10. Lower the windrower to the ground.
11. Retrieve the anti-shimmy dampeners and hardware from
the bag in the toolbox.
%
$
&
'
(
Figure 3.28: Anti-Shimmy Arm
–
Left Side
12. If the windrower already has casters installed:
a.
Remove retaining ring (A).
b.
Remove and discard yellow spacer (B).
c.
Retrieve the key and the arm from the toolbox.
d.
Install key and arm (D). Secure the arm with retaining
ring (E) on the caster shaft as shown.
e.
Tighten nut (C), and torque it to 195 Nm (144 lbf·ft).
$
%
&
'
Figure 3.29: Anti-Shimmy System
–
Left Side
13. Attach the barrel end of anti-shimmy dampener (A) to the
forward hole in support (B) with one M16 x 75 flange head
bolt (C) and one M16 lock nut (D). Install the bolt from
under the support. Do
NOT
fully tighten the hardware yet.
