215627
122
Revision A
$
Figure 5.122: Left Cab-Forward Platform
12. Pull platform (A) towards the cab until it stops and the latch
is engaged.
$
%
Figure 5.123: Electrical Connection
DANGER
Check to be sure all bystanders have cleared the area.
13. Start the windrower engine.
14. Extend center-link (A) fully. Ensure that there is some slack
in harness (B).
15. Retract center-link (A) fully. Ensure that there is not an
excessive amount of harness (B) hanging down.
16. Turn off the windrower engine, and remove the key.
17. Adjust harness (B) as needed.
18. Tighten all the cables along the harness.
19. If necessary, calibrate both the knife drive and header position sensors on the windrower. Calibrate both the knife
drive and header position sensors whenever you are:
•
Attaching the header to the windrower for the first time
•
Changing the speed sensor or hydraulic drive motor on the header
•
Changing the header drive pump associated with the knife drive, Harvest Performance Tracker (HPT), or the master
controller on the windrower
For instructions, refer to
5.7.1 Calibrating the Knife Drive on the Harvest Performance Tracker Display, page 139
and
5.7.2 Calibrating Header Position Sensors on the Harvest Performance Tracker Display, page 142
Rotary Disc Only Configuration
–
Hard-Plumbed Connections
The rotary disc configuration allows the windrower to operate with compatible rotary disc headers. The hydraulic
connections must be torqued correctly when using hard-plumbed fittings.
IMPORTANT:
To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all (fixed and
movable) hydraulic couplers.
