215627
58
Revision A
4.2
Performing Operational Checks
After performing all pre-start checks and starting the engine, the operating features of the windrower should be inspected.
1.
Perform the final checks and adjustments listed on the following pages and the
Predelivery Checklist, page 159
(the
yellow sheet attached to this instruction) to ensure that the machine is field-ready.
2.
Ensure that the Operator or the Dealer retains the completed Predelivery Checklist.
4.2.1
Checking HPT Status Screen and Auto Lights
Confirm that the Harvest Performance Tracker (HPT) correctly recognizes whether or not a header is attached to the
windrower, and check that the cab lights automatically turn off when the operator leaves the cab.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
Figure 4.28: HPT Display
–
Boot-Up
1.
Open the cab door, turn the IGNITION switch to the ON
position, and confirm that the HPT display boots up and
shows the MacDon logo.
Figure 4.29: HPT Display
–
Header Disengaged
2.
Start the engine. For instructions, refer to
.
3.
If a header is attached, confirm that the HPT initially
displays the header-disengaged screen.
