214325
217
Revision A
Figure 5.163: John Deere Combine Control
Console
1.
Press button (A) and current raise/lower rate setting will
appear on monitor (the lower reading, slower rate).
2.
Use scroll knob (B) to adjust rate. The adjustment will
be saved automatically.
NOTE:
If page remains idle for a short period of time, it will
automatically return to previous page. Pressing check
mark button (C) will also return monitor to
previous page.
Figure 5.164: John Deere Combine Display
NOTE:
The numbers depicted on displays in these illustrations
are for reference purposes only; they are not intended to
represent specific settings for your equipment.
5.1.11
John Deere S and T Series Combines
Checking Voltage Range from Combine Cab (John Deere S and T Series)
The auto header height sensor output must be within a specific range, or feature will not work properly.
Combine
Low Voltage Limit
High Voltage Limit
Minimum Range
John Deere S and T Series
0.7 V
4.3 V
3.0 V
Check sensor
’
s output voltage range from combine cab according to instructions that follow.
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
1.
Position header 150 mm (6 in.) above ground, and unlock adapter float.
