214325
97
Revision A
4.8
Centering Reel
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before making adjustments to machine.
Figure 4.13: Centering Reel
1.
Start engine and set header down on 150 mm (6 in.)
blocks (B) at the ends of header. Header should be in a
smile shape.
2.
Lower reel and adjust fore-aft position to 5 on reel arm
indicator decal.
3.
Stop engine and remove key from ignition.
4.
Disengage float locks and wing locks.
5.
Manually rotate reel to position a tine tube above
cutterbar.
6.
Measure clearance (A) between reel tine tube and
endsheet at both ends of header. If the reel is centered,
the clearances will be the same. Refer to following
steps to center reel.
Figure 4.14: Center Support Arm
7.
Loosen bolts (D) on braces (E) at center support arm.
8.
Move forward end of reel support arm (F) laterally as
required to center reel.
9.
Tighten bolts (D) and torque to 359 Nm (265 lbf·ft).
