214325
263
Revision A
CAUTION
Check to be sure all bystanders have cleared the area.
1.
Position header 150 mm (6 in.) above ground, and unlock adapter float.
Figure 5.269: Float Lock
2.
Check that float lock linkage is on down stops
(washer [A] and nut [B] cannot be moved) at both
locations.
NOTE:
If header is not on down stops, float is too light.
Readjust float if necessary.
NOTE:
If header is not on down stops during next two steps,
voltage may go out of range during operation causing a
malfunction of auto header height control (AHHC)
system.
Figure 5.270: Float Indicator Box (Most
Common 5 Volt AHHC Sensor
Assembly Shown)
3.
Adjust cable take-up bracket (B) (if necessary) until
pointer (A) on float indicator is on 0.
