214805
70
Revision A
1027289
A
B
C
Figure 3.144: M1170/M120 Configuration with
Extensions for 5.5 m (18 ft.) Header
•
Knife return extension (A)
–
Connects to tee on port A
•
Knife pressure extension (B)
–
Connects to port B
•
Case drain extension (C)
–
Connects to tee on knife motor
case drain port
10273601027360
A
B
Figure 3.145: M1170/M1240 Configuration for 4.9 m
(16 ft.) Header
•
Hose (A)
–
Connects to tee on knife motor port A and to port
KP on manifold
•
Hose (B)
–
Connects to tee on knife motor port B and to knife
return port OR2 on manifold
NOTE:
The illustration at right shows a 4.9 m (16 ft.) header. The
extensions required on 5.5 m (18 ft.) header are
NOT
shown
in the illustration.
NOTE:
The hose bundle (included in MD# B5998) required for
attaching the header to the windrower is
NOT
shown in the
illustration.
3.18.2
Hydraulic Drive Hose Routing (A40DX GSS and M1 Series Windrowers)
IMPORTANT:
If attempting to attach an A40D GSS Header to an M1170 or M1240 Windrower, the A40D SP Grass Seed Auger Conversion
kit (MD #B6384) must first be installed. This kit includes a new manifold and hydraulic hose bundle required for operation
with an M1 Series Windrower, and effectively converts an A40D GSS header into an A40DX GSS header. The Reel Speed
Control kit (MD B6604) is factory-installed for model year 2019 A40DX GSS headers.
The following illustrations show the correct, factory-configured hose routing for an A40DX GSS header used with an M1170
or M1240 SP Windrower:
For 5.5 m (18 ft.) headers only:
