214805
100
Revision A
Setting Knife Speed with Expansion Module (MD #B4666)
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1007761
A
B
Figure 5.33: Operator Console
1.
Press SELECTOR button (B) on the ground speed lever (GSL)
until the CDM (A) displays the knife speed in SPM (strokes
per minute). This indicates that optional expansion module
(MD #B4666) is installed.
2.
If knife speed is
NOT
displayed, the optional expansion
module is not installed. Proceed to
without Expansion Module (MD #B4666), page 101
3.
Compare reading to Table
If required, adjust the knife speed as follows:
1009607
B
A
Figure 5.34: Knife Drive Pump
4.
Shut down engine, and open engine hood.
5.
Locate knife drive pump (A) and knife speed adjuster
screw (B) under the right (cab-forward) side of the
windrower.
NOTE:
The knife speed adjuster screw may have a plastic cap (B)
covering it. Pull this cap off to expose the screw.
