214805
8
Revision A
3.2
Installing Skid Shoes
If the Skid Shoes kit is
NOT
supplied, proceed to
3.3 Installing Gauge Rollers, page 9
. Otherwise, proceed as follows:
NOTE:
This kit may be installed later in the header assembly sequence, but it may be easier prior to laying the header down.
1008987
A
B
Figure 3.2: Skid Shoe Bundle
1.
Unpack skid shoe bundle.
2.
Remove two clevis pins (A) from each skid shoe.
3.
Remove nuts, bolts, and clips (B) from skid shoe.
1005846
A
B
Figure 3.3: Skid Shoe Hardware
4.
Position skid shoe below cutterbar and insert tabs on skid
shoe into slots (A) in frame. Secure with clevis pin (B).
1005403
A
B
Figure 3.4: Skid Shoe Installed
5.
Attach clips (A) with bolts and nuts removed earlier in this
procedure to secure skid shoe to cutterbar.
NOTE:
Use a socket and ratchet wrench to access the nuts.
6.
Tighten nuts.
7.
Remove clevis pin (B) and adjust skid shoe to desired
height. Reinstall two clevis pins (B) and secure with
lynch pins.
8.
Repeat previous steps for opposite side. Set both skid shoes
to the same position.
